Search results for "Contour method"
showing 5 items of 5 documents
Comparison between doppler-echocardiography and uncalibrated pulse contour method for cardiac output measurement. a multicenter observational study
2016
Objectives: Echocardiography and pulse contour methods allow, respectively, noninvasive and less invasive cardiac output estimation. The aim of the present study was to compare Doppler echocardiography with the pulse contour method MostCare for cardiac output estimation in a large and nonselected critically ill population. Design: A prospective multicenter observational comparison study. Setting: The study was conducted in 15 European medicosurgical ICUs. Patients: We assessed cardiac output in 400 patients in whom an echocardiographic evaluation was performed as a routine need or for cardiocirculatory assessment. Interventions: None. Measurements and Main Results: One echocardiographic car…
Measuring Inaccessible Residual Stresses Using Multiple Methods and Superposition
2010
The traditional contour method maps a single component of residual stress by cutting a body carefully in two and measuring the contour of the cut surface. The cut also exposes previously inaccessible regions of the body to residual stress measurement using a variety of other techniques, but the stresses have been changed by the relaxation after cutting. In this paper, it is shown that superposition of stresses measured post-cutting with results from the contour method analysis can determine the original (pre-cut) residual stresses. The general superposition theory using Bueckner’s principle is developed and limitations are discussed. The procedure is experimentally demonstrated by determini…
KNOWN RESIDUAL STRESS SPECIMENS USING OPPOSED INDENTATION
2009
In order to test new theories for residual stress measurement or to test the effects of residual stress on fatigue, fracture, and stress corrosion cracking, a known stress test specimen was designed and then fabricated, modeled, and experimentally validated. To provide a unique biaxial stress state, a 60 mm diameter 10 mm thick disk of 316L stainless steel was plastically compressed through the thickness with an opposing 15 mm diameter hard steel indenters in the center of the disk. For validation, the stresses in the specimen were first mapped using time-of-flight neutron diffraction and Rietveld full pattern analysis. Next, the hoop stresses were mapped on a cross section of two disks usi…
MAPPING MULTIPLE RESIDUAL STRESS COMPONENTS USING THE CONTOUR METHOD AND SUPERPOSITION
2008
The standard contour method determines the residual stress component normal to the plane of measurement. This talk presents extensions to the contour method to allow determination of multiple stress components. Two extensions are presented, both using additional stress measurements and then superposition to determine the original residual stresses. The first extension involves making additional cuts to determine stresses on multiple cut planes, using only the contour method. The second extension involves measuring in-plane stresses on the surface exposed by the original cut, using x-ray diffraction and hole drilling in this case. Experiments were preformed on indented disks of both 316L sta…
Measuring Multiple Residual-Stress Components using the Contour Method and Multiple Cuts
2009
The conventional contour method determines one component of residual stress over the cross section of a part. The part is cut into two, the contour (topographic shape) of the exposed surface is measured, and Bueckner’s superposition principle is analytically applied to calculate stresses. In this paper, the contour method is extended to the measurement of multiple residual-stress components by making multiple cuts with subsequent applications of superposition. The theory and limitations are described. The theory is experimentally tested on a 316L stainless steel disk with residual stresses induced by plastically indenting the central portion of the disk. The multiple-cut contour method resu…